Description

Send Inquiry

An EDI water purification plant for semi-conductors is usually part of an Ultra Pure Water (UPW) system. In this context, EDI is the "ion-removal polishing step" after RO that helps you reach extremely low conductivity-then additional UPW polishing removes TOC, silica/boron, dissolved gases, bacteria, and particles to meet fab requirements.

Why EDI is the Standard for Semiconductors

Traditional ion-exchange resin beds are largely being replaced by EDI in semiconductor plants due to several critical technical advantages:

Zero Ionic Leakage: Unlike standard resin beds that can "leak" ions as they become exhausted, EDI provides a constant, high-purity stream because the resin is continuously regenerated by an electric field.
Chemical-Free Environment: Semiconductors require an incredibly stable environment. EDI uses electricity instead of hazardous acids and caustics, eliminating the risk of chemical fumes or accidental spills that could contaminate the "Clean Room" air.
Low TOC and Silica Removal: EDI is highly effective at removing weakly ionized species like Silica ($SiO_2$) and Boron, which are notoriously difficult to strip but are devastating to semiconductor yields.
Modular Scalability: Semiconductor "Fabs" are massive. EDI systems are modular, allowing engineers to scale water production up or down to match the number of lithography or etching tools in operation.

Typical EDI Water Purification Plant For Semi-Conductor

In a semiconductor facility, the EDI plant is the "heart" of the polishing loop, sitting between the Reverse Osmosis (RO) stage and the final point-of-use filters:

Primary Treatment (Double-Pass RO): Removes 99% of bulk contaminants. The high-quality permeate from the second RO pass serves as the feed water for the EDI.
Degasification: Removes dissolved $O_2$ and $CO_2$. This is critical because dissolved gases can cause bubbles on the wafer surface and interfere with the EDI's efficiency.
EDI Module: The water is polished to 15–18 M$\Omega$·cm. The electric field ensures the ion-exchange resin remains in a permanently "charged" state.
UV & Ultrafiltration (UF): Final "polishing" at 18.5 nm or 254 nm UV wavelengths to destroy any trace organics (TOC) and UF membranes to catch any remaining sub-micron particles.

Key Design Points That Matter Most

Feed to EDI must be very clean: low hardness, low silica scaling risk, low oxidants (chlorine), low SDI.
Degassing (CO₂ removal) often improves resistivity and reduces EDI load.
Materials & hygiene: UPW loops usually use high-purity materials (e.g., PVDF/PFA/EP-grade SS depending on spec) and constant recirculation to prevent contamination.
Monitoring: resistivity, TOC, silica, DO, particle counts, flow/pressure, temperature-plus alarms/trending.

If you tell me these 4 items, I can suggest a suitable EDI Water Purification Plant For Semi-Conductor: